![]() Cut the rafter tails long enough to deflect rainwater, but make sure there is enough clearance for the door (if it is to open outwards). Use the first rafter as a pattern for all the rest. Mark the exact location by laying trial pieces on the floor. Drill the holes carefully, from both sides.Ĭut lap joints in the tops of the 3″×5″ rafters, and cut bird’s-mouth notches where they will rest on the top plates. The 4″×4″ braces should be fastened with oak pegs (treenails or “trunnels”) passing right through the posts. Make the lap joints on the top plates, and set them upside-down on the sill beams while you mark, cut and fit the studs, braces and girts. Set out the base, level and square, on concrete blocks. Use a level and check the diagonals for square.Ĭut lap joints on the ends of the 6×6 pressure- treated sill beams, using a coarse-cut timber saw. Lay out the shed with mason’s string and four wooden stakes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |